Houpad wall formwork

Metal frame with playwood surface - no use of additional connectors and creating a strong structure to withstand different concrete pressures

One of the most modern methods of wall formwork is Plywood. In this system, the formwork surface is made of plywood and its backrest (frame) is made of metal; due to the use of plywood surface instead of metal sheet, in addition to be suitable for exposed concrete operation, it is very lightweighted too.

Although the plywood wall formwork creates a lighter structure than the metal one, but in terms of durability and efficiency and creating an exposed concrete surface, it works much better than similar metal systems. Plywood panels are easily connected to each other by clamps.

Product Specifications

Execution speed:
High execution speed of unilateral and bilateral wall systems with the least manpower at the project site

Few connectors:
Minimal use of formwork requirements for assembly and preventing the use of various and unnecessary parts in panels’ installation.

Exposed concrete:
Due to the use of plywood surface and large panels with the least construction joint

Creating a completely exposed concrete surface
Easy transportation by tower crane
Connectable to side panels
High execution speed
Light weight
Cost-effective system in terms of implementation
Adjustable to determine concrete pressure
Simple and adjustable connectors
Sealing walls implementation
Easy transportation to the project
Compatibility with other Playwood systems

Procedure

Hopadwalld

The plywood surface riveted at the factory site, and all form’s joints are sealed by mastic.

3 copy

The forms will be fully implemented at the project site by Medhat assembly team and delivered to the contractor.

AB17 copy

In two-way systems, the forms are connected to each other on both sides by tie rod, nut, plate and tie cone.

5 copy

The forms are secured by pull-push props which are attached to the ground on one side and to the panels on the other.

12 copy

Wood can also be used as easy filler between forms. The connection between forms and wood is done by a clamp.

x9 copy

Depending on the volume of wall concreting, the houpad wall forms are produced with different backrests.

7 copy

The working platform and guardrail post are connected to the panel at the form’s upper part. These components are installed to comply with HSE principles at the project site during concreting and formwork.

8 copy

To increase safety and prevent the worker from falling while working on the platforms; scaffolding pipe, small width wood or retaining guard net are used horizontally.

copy

Special corners of height appropriate to the forms are used in the formwork system.

10 copy

Depending on the type of use, the plywoods are depreciated after several stages of concreting, so their surfaces can be easily changed at the project site.

11 copy

The forms are connected to each other by steel clamps. Hammering the steel clamp brings the panels closer together and prevents the concrete from leaking out.ش

Projects

Nothing to show. You must configure the data source of the widget.

The Disqus commenting system can not load because no shortcode value has been entered into the plugin parameters.

Houpad wall formwork

Product Specifications

Procedure

documents

Media

Mobile Menu